900V液冷双向DCDC变流器 | 480A·260kW·IP67·98%高效·液冷高防护 | 900V Liquid-Cooled Bidirectional DC-DC Converter | 480A · 260kW · IP67 · 98% Efficiency · Liquid-Cooled
|
出品方:稳利达电力电子 | Wenlida Power Electronics |
产品简介 | Product Introduction
WLD-900V480A260KW67H为液冷双向DC/DC变流器,由稳利达电力电子采用全数字化设计,实现电压、电流双环反馈。产品高压端0-950Vdc(额定600V)、低压端为高压电压×0.05~高压电压×0.95,两端**大电流480A、**大功率260kW;转换效率98%(半载至满载均>99%),电压精度±0.5%FS,静态损耗电流仅20mA(空载),辅助电源220VAC或直流定制(50W)。采用液冷散热(进水≤60℃/出水≤70℃、额定流量15L/min、CQC18公头),IP67高防护,工作温度-20~+60℃,海拔**4000米(>3000米降额);支持高压过压/欠压、防反接,低压过流/过压/欠压/过温/短路保护及下垂并联定制,启动与电压/电流控制可通过CAN或RS485(Modbus RTU)远程设置。适用于高压直流变换、储能、高防护车载/船用电源、大电流直流测试及直流微电网等场景。
WLD-900V480A260KW67H is a liquid-cooled bidirectional DC-DC converter, delivered by Wenlida Power Electronics with an all-digital design and dual-loop voltage/current feedback. Its HV side is 0-950Vdc (rated 600V) and the LV side spans HV×0.05 to HV×0.95; both ends handle up to 480A and 260kW. Efficiency is 98% (>99% from half load to full load), voltage accuracy ±0.5%FS, quiescent current only 20mA (no-load), auxiliary power 220VAC or DC customization (50W). It uses liquid cooling (inlet ≤60℃/outlet ≤70℃, rated flow 15L/min, CQC18 male connector), IP67 high protection, -20~+60℃ operating temperature and up to 4000m altitude (derated above 3000m). It supports HV over-/under-voltage and reverse-polarity protection, LV over-current/over-voltage/under-voltage/over-temperature/short-circuit protection and droop-parallel customization; start-up and voltage/current control can be remotely configured via CAN or RS485 (Modbus RTU). It suits high-voltage DC conversion, energy storage, high-protection on-board/marine power, high-current DC testing and DC micro-grids.
产品原理说明 | Product Topology Description
图1:900V液冷双向DCDC变流器应用场景 | Figure 2: 900V liquid-cooled bidirectional DC-DC converter application scenario
本产品为液冷双向DC/DC变流器,采用全数字化设计与电压、电流双环反馈,在高、低压端之间实现双向大功率能量交换。需注意高压侧电压必须高于低压侧,实际运行中应满足高压电压×0.05 < 低压电压 < 高压电压×0.95,即高、低压之间需保留5%压差,否则易引起设备损坏。产品采用液冷散热,进水≤60℃、出水≤70℃、额定流量15L/min(CQC18公头),支持底部支架固定或左右两侧挂耳固定(M6螺栓)。
This product is a liquid-cooled bidirectional DC-DC converter with an all-digital design and dual-loop voltage/current feedback, enabling bidirectional high-power energy exchange between the HV and LV sides. The HV voltage must be higher than the LV voltage: HV×0.05 < LV < HV×0.95, i.e. a 5% differential is required, otherwise the equipment may be damaged. It uses liquid cooling (inlet ≤60℃, outlet ≤70℃, rated flow 15L/min via CQC18 connector) and supports bottom-bracket or side-ear mounting with M6 bolts.
完整参数表 | Complete Parameter Tables
表1 基本参数 | Table 1 Basic Parameters
|
端口 Port |
项目 Item |
参数 Parameter |
|
低压端 |
额定电压 Rated Voltage |
可设置 Configurable |
|
电压范围 Voltage Range |
高压电压×0.05 ~ 高压电压×0.95 |
|
|
**大电流 Max. Current (A) |
480 |
|
|
**大功率 Max. Power (kW) |
260 |
|
|
高压端 |
额定电压 Rated Voltage |
可设置(额定 600V) |
|
电压范围 Voltage Range (Vdc) |
0 - 950 |
|
|
**大电流 Max. Current (A) |
480 |
|
|
**大功率 Max. Power (kW) |
260 |
|
|
通讯 Communication |
RS485 |
1路,Modbus RTU,9600波特率 |
|
CAN |
2路,兼容CAN2.0A/B,125K/250K/500K/1M波特率可设 |
表2 高压端电气特性 | Table 2 HV-Side Electrical Characteristics
|
项目 Item |
单位 Unit |
**小值 Min |
额定值 Rated |
备注 Note |
|
电压 Voltage |
V DC |
0 |
600 |
精度 ±0.5%FS |
|
效率 Efficiency |
% |
|
98% |
额定输入,>99% @ 半载至满载 |
|
**大电流 Max. Current |
A |
|
480 |
低压端电流同时小于 480A |
|
静态损耗电流 Quiescent Loss |
A |
|
20mA |
空载 |
|
辅助电源 Aux. Power |
W |
|
50 |
220VAC 或直流定制 |
表3 保护功能 | Table 3 Protection Functions
|
保护项 Protection |
说明 Description |
|
高压过压/欠压 HV Over/Under-voltage |
保护点/恢复点可设置;输入过压/欠压时关闭输出,到达恢复点后自恢复 |
|
防反接 Reverse-Polarity |
支持 |
|
过流保护 Over-current |
保护点可设置;输入限流、输出恒压,退出限流后电压自恢复 |
|
过压/欠压保护 Over/Under-voltage (LV) |
保护点可设置;关闭输出并上报、存储,正常时自动恢复 |
|
输出并联 Parallel |
定制版:下垂并联 |
|
过温保护 Over-temperature |
降至安全温度后自动恢复 |
|
短路保护 Short-circuit |
低压短路保护;高压直流熔断机制 |
|
启动/电压/电流控制 Control |
通过 CAN 或 RS485 总线远程使能与设置(协议由我方提供) |
表4 环境、液冷与安规 | Table 4 Environment, Cooling & Safety
|
项目 Item |
参数 Parameter |
|
工作温度 Operating Temp. |
-20 ~ +60℃ |
|
工作湿度 Operating Humidity |
5% ~ 95%,无冷凝 |
|
存储温度/湿度 Storage |
-40 ~ 125℃ / 5 ~ 95% |
|
海拔高度 Altitude |
4000米(>3000米需降额使用) |
|
冷却方式 Cooling |
液冷;进水 ≤60℃ / 出水 ≤70℃,额定流量 15L/min,CQC18公头 |
|
安装方式 Mounting |
底部支架固定 或 左右两侧挂耳固定(M6螺栓) |
|
压差要求 Voltage Differential |
HV×0.05 < LV < HV×0.95(高压必须高于低压) |
|
绝缘电压 Withstand Voltage |
输入-输出 非隔离;输入/输出-机壳 2000VDC 60s ≤10mA 无击穿飞弧 |
|
绝缘阻抗 Insulation Resistance |
1000VDC ≥10MΩ/min |
|
噪声 Noise |
<40dBA @1m(额定工作状态) |
|
防护等级 Protection Class |
IP67 (IEC529) |
|
尺寸 Dimension (L×W×H) |
600 × 450 × 132 mm(含密封盖板与安装底座) |
应用场景 | Application Scenarios
典型应用 | Typical Applications
? 储能系统双向充放电变换
? 高压直流变换与直流微电网
? 高防护车载、船用、户外直流电源
? 动力电池检测、大电流直流测试电源
? 电动工程机械、港口势能回收高压直流变换
? Bidirectional charge/discharge conversion for energy storage
? High-voltage DC conversion and DC micro-grids
? High-protection on-board, marine and outdoor DC power
? EV-battery testing and high-current DC test power
? HV DC conversion for electric engineering machinery and port potential-energy recovery
|
定制说明:稳利达电力电子本系列产品支持定制开发,可根据电压等级、电流、功率、并联方式与通讯协议灵活配置,适配不同高压大功率直流应用需求。 Customization Note: Customization available by Wenlida Power Electronics. Voltage class, current, power, parallel mode and communication protocol can be flexibly configured according to site conditions to meet various high-voltage high-power DC application requirements. |